Skip Navigation
Posts
2
Comments
8
Joined
2 yr. ago
  • This is the right answer. You're hot end is pulling tight and causing this skew.

  • Air Gradient. I bought their DIY kit.

    Cheers, Henry.

  • Peak DOS

  • Hard Drivin'?

    I want one of the stick shift arcade machines so bad.

  • Well, duh. That just means that 93-84% of Redditors are bots. Bots didn't know there was a shutdown, so those bots kept slamming reddit. So with that data I now can assume Reddit was only 7-16% human.

  • Its from Siraya Tech, it's pretty handy.

  • 3DPrinting @lemmy.world
    henry_rowengartner @lemmy.world

    New Bottle of AnyCubic Grey

    Was using the bottle that came with my Creality Halot One, it was flesh colored. Tried a test with the basic AnyCubic. Came out better than the Creality by far.

    Bottom Layer: 27S Layers: 3.5S

    Going to start bringing in these settings.

  • Yeah new cars usually have the ability to do that themselves and also usually do it when safe.

    They auto start when power is needed or if the situation changes. Eg: touch the steering or gas pedal. Another example is my car will auto start it too many cars are around me.

    Shutting your non-auto starting car off and then having an emergency happen could land your ass in trouble with insurance and the law. If you're on the road, your car should be running (unless it was designed this way). Of course people mentioned wear and tear, so that too.

    Cheers -Henry

  • 3DPrinting @lemmy.world
    henry_rowengartner @lemmy.world

    Sad Pepe | Creality Halot One

    Still going through my included bottle of resin, they sent me flesh color. This is my first venture into resin printing. Ive been FDM printing for years now, have a few Ender 3s.

    Waiting on a new bottle of AnyCubic's HD grey :)

  • Honestly it was easier than I expected. I have a fairly new home and it has an HRV. I replaced it's paper filters with MERV 8. I also picked up an Air Gradient, slick little project.

    I change my filters about everything 3 months, they get pretty gnarly. I filter the air on the way out with a basic screen because it passes over the blower and...by design it would get absolutely filthy in short order.

    I made a bunch of "sensors" in HA to calculate the indoor AQI, and average.

    Cheers.

  • My Air Quality monitoring. I monitoring CO2, VOCs, PM and such. I then have automations run the air exchanger. They say air inside is 5X more polluted then outside I have the opposite.