Skip Navigation
InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)AN
Aniki 🌱🌿 @ aniki @lemm.ee

🌱🌿 Use Linux. Ride bikes. Eat plants. 🌱🌿

Posts
3
Comments
1,961
Joined
2 yr. ago
  • It was far more nuanced than that. They also wanted their own lane on 91 so they wouldn't have to deal with Boston traffic.

    https://www.bostonmagazine.com/news/2015/06/30/boston-2024-olympic-lanes/

    https://www.nytimes.com/2015/06/30/sports/olympics/bostons-revised-24-bid-criticized-as-incomplete.html?_r=0

    • “Mass media encouraging citizens and tourists to use public transportation and carpooling”
    • “Flexible hours at local businesses”
    • “Rerouting long-haul trucking around the city”
    • “Intelligent highway systems technology”
    • “Manually-controlled traffic lights”
    • “New one-way streets in busy areas to create better flow”

    Never been more proud to go tell the IOC to go fuck themselves with a huge cactus.

  • homeassistant @lemmy.world
    Aniki 🌱🌿 @lemm.ee

    Finally! My own working LCARs panels!

    I've been putting this off for way too long but I finally installed the LCARs theme in my HA and got to work redesigning all my dashboards.

    homeassistant @lemmy.world
    Aniki 🌱🌿 @lemm.ee

    ESPHome advanced troubleshooting

    I started mucking about with ESPHome yesterday and setup a WROOM with an AHT22 temp/humidity sensor. Running the wizard and adding the configs is easy-peasy. I started to have issues as soon as I wanted to flash.

    • If the AHT22 is plugged in, I cannot flash the device over USB.
    • I can check the serial logs once the device is flashed and then plug in the AHT22 once the device is booted and get readings, but
    • Once I unplug the ESP32 from the serial port and plug it into a power supply, I got nothing. No network activity at all.
    • Unplug the AHT22, plug into the power source, wait a few seconds, plug in the AHT22 has seemed to work correctly this morning and HA is pulling data but I tried that last night a few times and it didn't work -- so unsure why it's working this morning other than strange timing when I'm plugging the thing back in.

    I am using the basic esp32dev firmware, which I am assuming works because it DOES work, eventually, but I'm not confident I'm using the r

    Prepper Forum @lemm.ee
    Aniki 🌱🌿 @lemm.ee